What it is
A rate confirmation, rate con for short, is the written agreement between a freight broker and a motor carrier for one load. The broker books the carrier by phone or through a load board, then sends the rate confirmation to put the booking in writing: the stops, the appointment times, the equipment, the rate, and the conditions the carrier is agreeing to. The carrier's dispatcher signs it and sends it back, and the truck is dispatched. Some brokers call it a load confirmation; a shipper that books carriers directly without a broker sends a load tender that does the same job.
It is not the only agreement between the two companies. Most brokers have each carrier sign a broker-carrier agreement once, at setup, covering insurance, payment terms, liability and the rules that apply to every load. The rate confirmation sits under that master agreement and carries only what is specific to this load. When the two disagree, the master agreement usually says which one wins.
Nothing on this page is legal advice. It describes how the document is used on dispatch desks, not what a court would make of any line on it.
What is on it
Formats vary by TMS, but a complete rate confirmation carries the same dozen things.
- The parties. The broker's name, MC number and contact, and the carrier's legal name, MC or DOT number and dispatcher contact. The carrier named here is the one allowed to haul the load.
- Load and reference numbers. The broker's load number, the shipper's order or PO number, and the pickup number the shipper's dock will ask for. A driver without the pickup number waits at the gate.
- The stops, with appointment windows. Each pickup and delivery with its address, the date, and either an appointment time or a first-come-first-served window. This is the field the tracking desk cares about most.
- The freight. Commodity, piece count, weight, equipment type (dry van, reefer with its set point, flatbed with tarp requirements), and anything that needs special handling.
- The rate. The line haul, fuel if it is separate, and any accessorials agreed up front: stop-offs, lumper, tarping, driver assist.
- Free time and detention. How long the truck can wait at each stop before detention applies, the hourly rate, any cap, and what the carrier has to do to claim it, often a call to the broker before free time runs out.
- Paperwork and payment terms. When the signed bill of lading or proof of delivery is due, where to send the invoice, how many days to payment, and any quick-pay option.
- Tracking requirement. Whether the carrier must share a tracking link, run the broker's app or accept check calls, when tracking has to start, and what happens when it stops. The tracking clause guide covers how to write this one so it changes behaviour.
- Conditions and prohibitions. No double brokering, no rebrokering to another carrier, no rail, seal number recorded on the BOL, temperature logs on a reefer, late fees for paperwork.
- Signatures. Both sides, with dates. An unsigned rate confirmation is an offer.
Rate confirmation, BOL, POD, invoice
Four documents travel with every brokered load, and new dispatchers mix them up because three of them can be the same piece of paper at different moments.
| Document | Who issues it | When | What it proves |
|---|---|---|---|
| Rate confirmation | Broker, signed by the carrier | At booking, before dispatch | The terms: stops, times, rate, conditions |
| Bill of lading (BOL) | Shipper, signed by shipper and driver | At pickup | What freight was tendered, in what condition, to which carrier |
| Proof of delivery (POD) | The BOL, signed by the receiver | At delivery | The freight arrived, when, and in what condition |
| Carrier invoice | Carrier to broker | After delivery | What is owed, with the rate confirmation and POD attached |
The rate confirmation says what was agreed. The BOL and POD say what happened. A payment dispute is almost always a gap between the two: a stop on the BOL that was not on the rate confirmation, a delivery time on the POD hours past the appointment, in and out times on the POD that the rate confirmation's free time makes worth money.
What the tracking desk reads
Carrier sales reads the rate. The person tracking the load reads five other fields, before the truck is dispatched, because each of them starts a clock.
- Appointment windows. A load can only be late against a time. “Deliver Thursday” with no window means no ETA can ever be wrong and no one can be warned. Get a time or a window on every stop, and get the receiver's hours if it is first come, first served. Late load detection is the comparison of a routed ETA with this field, run on every new position.
- Free time and the detention notice. Two hours of free time means the detention clock starts two hours after the GPS puts the truck inside the shipper's fence. A clause that says the broker must be told thirty minutes before detention starts is a reminder the desk has to make at ninety minutes. The detention guide covers what evidence settles the claim.
- The tracking requirement. If the rate confirmation says a tracking link is due before pickup, the desk has something to ask for at booking instead of after the truck has loaded.
- Pickup and reference numbers. Checked against what the driver has before arrival, so the first hour at the shipper is not spent on the phone.
- Paperwork deadlines. If the signed POD is due within 48 hours, the load is not finished at delivery, and the desk has one more thing to watch.
The habit that follows is to put those five fields on the load record on the day of booking, in the TMS or on the tracking board, before the truck moves. The signed rate confirmation is the source; the load record is the working copy everyone else looks at.
Gaps that cost money
The same handful of gaps show up in most disputes, and all of them are visible on the page before dispatch.
- “TBD” in the appointment field. The shipper had not confirmed the time when the load was booked, nobody updated the document, and the carrier shows up when it suits the driver. Reissue the rate confirmation once the time is set, or at least write the confirmed time on the load and tell the carrier in writing.
- A different carrier at the dock. The MC number on the rate confirmation is one company and the truck that arrives belongs to another. That is double brokering, which almost every rate confirmation prohibits, and the carrier you paid may not be the one that has your customer's freight. Check the MC on the truck against the MC on the page when the driver checks in.
- Free time with no notice rule, or a notice rule with no clock. The carrier bills six hours of detention; the broker says nobody called. A clear rule on the page, and a desk that watches the clock, settles it.
- A tracking requirement with no definition. “Tracking required” on its own does not say what counts, when it starts or how long a gap is a breach, so it changes nothing. The clause guide linked above has language to adapt.
Keeping it
Federal rules require a property broker to keep a record of each brokered transaction, including the consignor's name and address, the carrier's name, address and registration number, the bill of lading or freight bill number, the compensation received and who paid it, and any freight charges the broker collected with the date they were paid to the carrier. Those records are kept for three years, and each party to the transaction has the right to review the record of it (49 CFR 371.3). The rate confirmation, the BOL and the POD together are most of that record, which is one more reason to file them on the load rather than in an inbox.
For the tracking desk the useful record is wider than the rule: the signed rate confirmation, any revised version, the position history, the arrival and departure times at each stop, and the messages about the load, in one place with their times. The person answering a detention dispute six weeks later was probably not the person on the load.
Where software helps
Typing a rate confirmation into a load record is the part nobody enjoys and the part where appointment times get mistyped. LoadSignal reads a rate confirmation PDF into a load for review: upload it, or email it to your organization's import address from an approved sender, and the stops, appointments and carrier details are waiting in a review screen, prefilled. It never becomes a load until a person confirms it, and if a PDF cannot be read the load can still be finished by hand from the same screen. The carrier's tracking link goes on that screen too, so the link the rate confirmation asked for is captured at the same moment the load is created.
From there the fields on the page become the clocks on the board. The appointment windows feed the ETA comparison behind late load detection; the free time and detention rate on the customer record run the detention clock from the GPS arrival; the tracking thresholds are settings, so the free time on the page and the free time on the board match. Loads that come in from a TMS connection, a spreadsheet or the API are watched the same way. The product page shows the import, and track and trace is where the loads land once the clocks are running. Software does not read a TBD for you. Someone still has to call the shipper for the time, and check the MC on the truck against the MC on the page.
Questions dispatchers ask
Is a rate confirmation a contract?
In practice it is treated as the binding agreement for that one load once both sides have signed it, and it sits under the broker-carrier agreement that covers the relationship. What each clause is worth in a dispute depends on the wording and the state, so have counsel read your template. Nothing here is legal advice.
Who sends the rate confirmation?
The broker or 3PL that booked the load sends it to the carrier, usually by email, after the rate is agreed by phone or on a load board. The carrier signs and returns it before the truck is dispatched. A shipper that books carriers directly sends its own version, often called a load confirmation or load tender.
What is the difference between a rate confirmation and a bill of lading?
The rate confirmation is the agreement between broker and carrier: who hauls what, where, when and for how much. The bill of lading is the shipper's document for the freight itself, issued at pickup, listing the goods and signed by the shipper and the driver. The rate confirmation sets the terms; the bill of lading is the record that the freight moved under them.
What should a dispatcher check before the truck moves?
That the appointment times are real times and not blanks or TBD, that the pickup number and any seal or reference numbers are on the page, that the MC number matches the carrier that is actually sending a truck, that free time and detention terms are stated, and that the tracking requirement says what tracking means and when it starts.
Can a rate confirmation be changed after it is signed?
Yes, by a revised rate confirmation that both sides sign again, or by a written amendment both agree to. A rate or an appointment changed by phone and never written down is the start of most payment disputes. Reissue the document, keep both versions, and note on the load which one is current.